44-45
| Stroke/Stride Measurement |
|
|
|
| ||
|
|
|
|
| |||
|
| STROkE |
|
| |||
| Press [MODE] until you enter the Stroke Measure- |
| 180.0 |
|
| ||
| ment mode.The display will be as follows. |
|
|
|
| ||
| At the end of the first second, the display will |
| |||||
|
|
|
|
| |||
|
| STROkE |
| become steady. |
| ||
|
| 0.0 |
| If measurement is stopped in the first second |
| ||
|
|
|
| (stroke frequency > 180), error signal “ Err “ will |
| ||
| In the Stroke or Strides Measurement mode, |
| |||||
| be shown. After the first second has elapsed, |
| |||||
| the duration of 3 strokes is taken and the stroke |
| |||||
| the instantaneous measurement reading will |
| |||||
| frequency (counts per minute) is calculated. If the |
| |||||
| be shown. When you press [STOP • RESET], the |
| |||||
| stroke frequency falls out of the range of 10 - 180, |
| |||||
| display will show the steady stroke measurement |
| |||||
| “Err” will appear to show the error condition. |
| |||||
| reading. If the measurement lasts for more than |
| |||||
|
|
|
|
| |||
| Press [START • SPLIT] to start the measurement. | 18 seconds (stroke frequency < 10), an error signal |
| ||||
| During the 1st second, 180.0 will be shown and | “Err” will be displayed. When the measurement |
| ||||
| flashing as below. | is stopped, press [STOP • RESET] to reset the |
| ||||
|
|
|
| displayed reading to “0.0”. |
| ||
| 44 |
|
| 45 |
| ||
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
46-47
Speed Mode (AX602M500 Model only)
Press [MODE] until you enter the Speed mode. The display will be as follows.
Distance indicator (only
used in speed mode
° Distance
° Lap time
°Total time
(Note that the default setting is KM. Hence “KM” icon will be ON.)
The upper line shows the distance or speed.The lap time is in the middle line, while the total time is displayed on the lower line.
46
In Speed mode, you can record a number of lap times and speeds for covering the distance you program into the chronograph. Before starting to use the Speed mode, you need to enter the dis- tance as explained below. Otherwise, the speed measurement won’t work. Nothing will happen when you press [START • SPLIT].
Distance Setting
Press [RECALL] (S1) for 2 seconds to enter setting mode.The unit icon flashes.
Distance units
47
