24-25
| Please note that if the stopwatch is running, no | Chronograph Data Recall Mode |
| ||
|
| ||||
| selection for chronograph operating modes can | Press [RECALL] in Chronograph mode to recall |
| ||
| be made until the stopwatch has been stopped |
| |||
| stored split/lap time memories.The mode message |
| |||
| and reset. |
| |||
| will be shown up for one to two seconds as mode |
| |||
| Segmented run memory for lap/split time storage. |
| |||
| message display is enabled. |
| |||
| A header consisting of the date/time stamp is |
|
|
|
|
|
|
|
|
| |
| attached to each segment to indicate the moment |
| RECALL |
|
|
| when you began recording the particular timing |
|
|
|
|
|
|
|
|
| |
| segment.To get to this feature, press [MODE] in | The split and lap time will be displayed on the |
| ||
| chronograph mode to enter DATA mode when |
| |||
| upper and the middle line respectively.The lower |
| |||
| the stopwatch has been stopped. Records for dif- |
| |||
| line shows the elapsed time between “start” and |
| |||
| ferent segments can be recalled, read or deleted. |
| |||
| this split. |
| |||
| Detailed operation in “DATA” mode is described in |
| |||
|
|
|
|
| |
| Data Mode section later in this manual. |
|
|
|
|
| 24 | 25 |
| ||
|
|
|
|
|
|
|
|
|
|
|
|
26-27
During data recall, the fastest lap time will be reviewed first.
Recall indicator 
(memory) 
View the slowest lap time by pressing [RECALL] again.
Press [RECALL] again to view the average lap time.
Average Lap Time indicator
Note: Press [RECALL] continually to review all the stored split/lap times.The sequence starts from the last record to the first record when the stopwatch is running and vice versa when the stopwatch has been stopped.
26 | 27 |
