![](/images/new-backgrounds/1120392/12039263x1.webp)
Startup Configuration
The Startup Configuration
Startup Configuration
Boot Display | [Auto] / [Both] |
Screen Expansion | [Disabled] / [Enabled] |
Resume on LAN Access | [Disabled] / [Enabled] |
Hotkey Beep | [Enabled] / [Disabled] |
Fast Boot | [Enabled] / [Disabled] |
Boot Drive Sequence: |
|
1st | [Hard Disk] |
2nd | [Floppy Disk] |
3rd |
−↓ = Move highlight bar, →← = Change Setting, F1 = Help
The following table describes the parameters in this
Parameter | Description | Options |
|
|
|
Boot Display | Sets the display on | Auto or Both |
| When set to Auto, the computer automatically |
|
| determines the display device when the computer |
|
| starts up. If an external display device (e.g., |
|
| monitor) is connected, it becomes the boot |
|
| display; otherwise, the computer LCD is the boot |
|
| display. When set to Both, the computer outputs |
|
| to both the computer LCD and an external display |
|
| device if one is connected. |
|
|
|
|
Screen Expansion | Enables or disables the screen expansion | Disabled or Enabled |
| feature. When enabled, DOS screens expand to |
|
| fill the LCD. |
|
|
|
|
Resume on LAN Access |
| Disabled or Enabled |
|
|
|
Hotkey Beep | Enables or disables a system beep when a | Enabled or Disabled |
| hotkey or key combination is pressed. |
|
|
|
|
Fast Boot | Fast Boot allows your computer to boot up and | Enabled or Disabled |
| resume from Sleep mode (including Standby and |
|
| Hibernation modes) faster. When enabled, the |
|
| operating system and BIOS communicate |
|
| information about |
|
| previous |
|
|
|
|
Boot Drive Sequence | Specifies the order in which the computer starts | 1st: Hard Disk, |
| up from. See the section below. | 2nd: Floppy Disk, |
|
| 3rd: |
|
|
|
26 | Chapter 2 |