AcerRouter 700 Series User Guide 7-5
An internal error has occurred.
"Sorry, the router is already being managed by "xxx.xxx.xxx.xxx".
Concurrent management is not allowed!"
Another SMART session is active on the PC with the specified address. The system
only allows one HTTP management session at any given time.
Parameters Accepted/ Applied parameter accepted
All parameters on the page were acceptable for use by the router.
"SPID1 unspecified"
This mesage is displayed when SPID (Subscription Party Indetification) is not
configured.
If you have selected NI-1, DMS-100, or ATT5EE (Multipoint) as your ISDN switch
type, then you need to configure both SPID numbers.
"Statistics Cleared"
The AcerRouter has completed a clear statistics operation on the link selected in the
System Status Monitoring Window.
"Syntax error, IP address should be xxx.xxx.xxx.xxx"
An invalid IP address is entered. A valid IP address should consist of a set of four
three-digit numbers. Each three-digit number should be a number between 0 and 255,
inclusive.
"Test successful"
The "Apply and Test" operation is successful.
"The extension number shouldn’t be all zeros"
An extension number or a SpeedDial number cannot start with a zero ("0").
"The Internet access time is configured successfully"
This message is displayed when the Internet access time configuration is accepted by
the router.
“The new password does not match the confirmed password”
The confirmed password entered is not the same as the new password entered during
the password operation.
“The new password is the same as the old password”
The new password is the same as the old password.
"The password has been changed"