Before you begin
2. Setup your AR Infinite Radio accounts
To simplify setup on the radio please complete these steps: | EN |
A.Find the Setup Information Card that contains your radio’s MAC address number (MAC:
B.Using any
•You will need to input your radio’s MAC address and PIN # to associate your radio with your personal settings.
3. Optional: Insert AAA batteries in the base of the radio
Follow the polarity markers in the battery compartment. The batteries power the clock and alarm* whenever the radio loses electricity. We recommend that you replace the batteries every year (or more often in case of multiple power outages) to avoid low battery power. Otherwise, clock and alarm accuracy may be affected when electricity supply is interrupted.
*When the battery backup functions, the clock display will not light. However, the function of alarm still occurs during the power interruption if remaining battery power is adequate.
4. For ARIRC205 only: Connect the AR
If your modem or router/hub/switch has only one LAN port and is connected to your PC, disconnect the Ethernet cable from the modem/router/hub/switch and connect it to the Enabler's LAN port.
LAN
LAN 
LAN 
LAN
LAN |
| power |
WAN | reset | POWER |
WAN |
|
|
Broadband modem or
Ethernet router/hub/switch
Electrical outlet
•Make sure the power, WAN, and WIRELESS LEDs are on. The MODE LED state will vary depending on your network configuration. If the MODE, WPS, and WIRELESS LEDs are blinking simultaneously, this indicates a possible connection error. Please review your connections and then press and hold the Enabler’s WPS button for 3 seconds (the MODE LED should start blinking) to rescan your network configuration. The Enabler may restart multiple times during this process and take up to two minutes depending on your network configuration. The MODE LED will stop blinking when this process is completed. Go to www.arinfiniteradio.com for more information.
9
