![](/images/new-backgrounds/1135472/13547223x1.webp)
SECTION 6 – INSTALLING THE HRU IN A SeaShelter™
BRACKET
The ACR SeaShelter™ is a discontinued product that looks like this:
Contents of the HydroFix™ HRU Kit that you will need:
HydroFix™ Replacement Hydrostatic Release Unit (E)
SeaShelter™ release rod (A)
Keyed bracket adapter (D)
Large cotter pin (H)
HRU expiration label (K)
Tools required:
Instructions: |
|
|
|
|
|
|
| |
1.) Remove | the | front | cover and |
|
|
|
| |
| Figure A |
|
| |||||
| carefully | release the EPIRB |
|
|
| |||
|
|
|
|
| ||||
| from the bracket. If the front |
|
|
|
| |||
|
|
|
|
| ||||
| cover of the SeaShelter™ |
|
|
|
| |||
| contains | a | metal | bushing |
|
|
|
|
| where the HRU rod is secured |
|
|
|
| |||
| close (see Figure A), use a |
|
|
|
| |||
|
|
|
|
| ||||
|
|
|
|
| ||||
| the bushing out of the top case and discard. This bushing prevents | |||||||
| the HRU rod from securing to the cotter pin. | |||||||
2.) | Remove the old HRU unit and rod from the bracket by pressing the | |||||||
| spring release back and sliding the old HRU up and out of the | |||||||
| bracket. |
|
|
|
|
|
|
|
3.) | Take SeaShelter™ release rod (A) and place it on top of the rod on | |||||||
| the HRU aligning the two sets of holes on the base (see Figure B). | |||||||
4.) | Place large cotter pin (H) inside the two holes, securing the two rods | |||||||
| together. |
|
|
|
|
|
|
|
|
|
|
| 11 |
|