Actiontec DSL Gateway User Manual
Reset Switch
Depressing the Reset switch for one or two seconds will power cycle the Gateway (similar to unplugging and then plugging in the Gateway’s Power cord). To restore the Gateway’s factory default settings, depress and hold the Reset switch for approximately 10 seconds. The reset process will start about 10 seconds after releasing the switch.
Power Port
The Power port is used to connect the Power cord to the Gateway.
NWarning: Do not unplug the Power cord from the Gateway during the reset process. Doing so may result in permanent damage to the Gateway.
Power Switch
The Power switch is used to power the Gateway on and off.
Technical Support
Basic Setup Support
If unable to access the Internet, look at the Internet light on the front of the Gateway. If the light is solid green, call the ISP immediately. If it is not solid green, call Qwest at
Other Problems
Contact the ISP if experiencing problems with:
sDHCP addressing configuration
sStatic IP addressing configuration
sTransparent bridging configuration Contact Qwest at
sDSL service outage support and repair
sDSL service installation support
6
