The Wireless Connectivity Expert

7. WINDOWS 2000 INSTALLATION GUIDE

Serial-IR Dongle Installation Manual

Note1.: If you do not change your computer BIOS setting, STOP here and go to Chapter 4 BIOS SETUP VERIFICATION.

Note2: If your computer system has installed some devices on the same com port before, you MUST properly uninstall the devices first. ACT-IR220L+/220L/200L would NOT work with your system any more if the devices are uninstalled improperly because some drivers are still there and cause conflicts with ACT-IR220L+/220L/200L driver. You HAVE to re-install your Windows 2000 again.

Note3: If your computer system has installed an FIR device before, ACT-IR220L+/220L/200L would NOT work with your system any more. You HAVE to re-install your Windows 2000 again.

Note4: If you want to use Virtual COM Port in your application, STOP here and change IR220L+/IR220L/IR200L to USB-IR Dongle.

Following are the instructions to properly install the ACT-IR220L+/220L/200L Dongle. You need a computer system with Windows 2000 already installed and at least one serial port available. The best choice for the system is a desktop PC.

A.Connect ACT-IR220L+/200L serial adapter to the COM Port of Desktop PC.

B.Startup your computer system

C.Click on Control Panel.

D.Double Click Add/Remove Hardware.

E.On Welcome to the Add/Remove

Hardware Wizard, click Next>.

♥ Copyright 2001-2008 ACTiSYS Corp. Page 13 of 37

Jul. 8, 2008

ACTiSYS Confidential Information

Version 1.5.1.1