The Wireless Connectivity Expert

5. WINDOWS 98 INSTALLATION GUIDE

Serial-IR Dongle Installation Manual

Note 1: If you have not verified your BIOS setup at this point, we strongly recommend you to refer back to the Chapter 4 BIOS SETUP VERIFICATION and verify your BIOS setup again.

Note 2: Verify that the COM port you will use to install ACT-IR220L/220L+/200L has not been already used or occupied by any hardware or software. We recommend users to completely delete any files or drivers that can interrupt clean fresh installation of our product.

Note 3: You are trying to install an SIR product. Your operating system can always be upgraded to use FIR products. However you can never downgrade from an FIR product to an SIR product. Therefore make sure that you have not previously installed any other FIR products on your system.

Followings are the instructions to properly install the ACT-IR220L+/220L/200L Dongle. You need a computer system with Windows 98 already installed and at least one serial port available. The best choice for the system is a desktop PC.

A.Connect ACT-IR220L+/200L serial adapter to the COM Port of Desktop PC.

B.Boot up your computer system.

C.Double Click My Computer on DeskTop.

D.Double Click Control Panel.

E.Double Click Add New Hardware on Control Panel Window.

F.Click Next>.

♥ Copyright 2001-2008 ACTiSYS Corp. Page 6 of 37

Jul. 8, 2008

ACTiSYS Confidential Information

Version 1.5.1.1