The Wireless Connectivity Expert

9. WINDOWS ME INSTALLATION GUIDE

Serial-IR Dongle Installation Manual

Note 1: If you have not verified your BIOS setup at this point, we strongly recommend you to refer back to Chapter 4 BIOS SETUP VERIFICATION and verify your BIOS setup again.

Note 2: Verify that the Com port you will use to install ACT-IR220L/220L+/200L has not been already used or occupied by any other hardware or software. We recommend users to completely delete any files or drivers that can interrupt clean fresh installation of our product.

Note 3: You are trying to install an SIR product. Your operating system can always be upgraded to use FIR products. However you can never downgrade from an FIR product to an SIR product. Therefore, make sure that you have not previously installed any other FIR product on your system.

Note 4: You may experience problems if you are using a beta version of Windows ME or an old upgraded edition of Windows ME. Some German version of Windows ME has also known on lacking of virtual COM port. This problem may make our device incapable of communicating with the other devices.

Following are the instructions to properly install the ACT-IR220L+/220L/200L Dongle. You need a computer system with Windows ME already installed and at least one serial port available. The best choice for the system is a desktop PC.

A.Connect ACT-IR220L+/220L/200L serial adapter to the COM Port of Desktop PC.

B.Boot up your computer system.

C.Double Click My Computer icon on DeskTop

D.Double click Control Panel icon.

E.Double click Add New Hardware icon. F. On the following boxes, click Next>.

♥ Copyright 2001-2008 ACTiSYS Corp. Page 19 of 37

Jul. 8, 2008

ACTiSYS Confidential Information

Version 1.5.1.1