TROUBLESHOOTING
Set Wireless I.D.
CALIBRATION
CALIBRATING THE DISPLAY CONSOLE:
The integrated wireless sensor is designed and engineered to provide accurate measurements, the internal fan aspiration ensures a proper
This wireless thermometer uses long range 433mhz radio frequency for communication.
In the event that you have reception problems due to interference, both the main unit and the wireless sensor have a selectable wireless ID. The ID switches are located within the battery compartments of the display console and the integrated wireless sensor.
You may choose A, B or C; but both the main unit and the wireless sensor ID's must match for successful synchronization.
A B CA B C
Both wireless ID
switches
must match
ambient air temperature in most cases.
If you feel that the placement or other environmental factors are affecting the indoor or outdoor temperature or humidity readings, the display console features a calibration feature for the indoor and outdoor temperature and humidity. This allows you to adjust the temperature or humidity reading up or down to compensate for the affected reading.
CALIBRATION PROCESS:
1.Select the affected category (outdoor temp example shown here)
2.Press AND HOLD the “DOWN”, “SET”, and “UP” buttons at the same time for
•The display console will “BEEP”, and all information on the display will disappear except for the value you are calibrating.
•You will note the “ 
” (calibrate) and the adjust up and down arrows next to the value you are calibrating.
IMPORTANT NOTICE
Have questions about product setup or operation? We’re here to help!
24/7 Support: www.acurite.com
Product Setup & Demo Videos | Register your Product |
Product Manuals | Support Forum |
Frequently Asked Questions | Submit Feedback & Ideas |
EMAIL: | TOLL FREE: |
| (877) |
| 7:00 a.m. - 7:00 p.m. CST |
Don’t forget! Register your product at: www.acurite.com
28
3.Press the “UP” or “DOWN” arrows to calibrate the display console reading up or down from the actual reading.
4.Press the “SET” button to confirm your calibration adjustment.
•Note that the calibration icon will stay illuminated next to all calibrated values. This is done so that you know that the value has been calibrated.
| the calibration icon will | |
press and HOLD all three buttons | stay illuminated after | |
value is calibrated | ||
for | ||
29 | ||
|
