Acu-Rite 1035 Setting Unit preferences, Basic Functions, Setup, Changing Units, Weather Select

SETUP

Setting Unit preferences

CHANGING UNITS

The Professional Wireless Weather Center comes pre-set from the factory in standard units ( mph, ºF, etc.). You may wish to change to metric units ( kph, ºC, etc.).

To change the units, you need to first select “SET UNITS?” in the center display area by pressing the up or down buttons.

1.Press the “ ” button to adjust the unit preference

2.Press the up or down buttons to select either “STAND” for standard or “METRIC” for metric units.

3.Press the “” button to confirm your desired selection

4.You will now see “WIND MPH”, press the up or down buttons to select either MPH, KPH, or KNOTS for wind speed unit of measurement.

5.Press the “” button again to confirm your desired selection

and exit “SET UNITS?” menu.

12

USE

Basic Functions

The Professional Wireless Weather Center was designed to give you the most often used information at a glance. The following is an overview of basic functions for everyday use.

WEATHER SELECT:

The “Weather Select” area of the display features heat index, dew point, wind chill calculations, as well as indoor temperature and humidity. Rainfall rate (inches per hour) can also be viewed in the weather select area. To change the “Weather Select” category, press the selection arrow button just to the left of the weather select display area.

	= Heat Index
	= Dew Point
	= Wind Chill
	= Indoor Conditions
press the selection arrow to	= Rainfall Rate (in./hr)
change the weather select display

WIRELESS SIGNAL RECEPTION ICON:

The display console features a “SENSOR” signal reception icon to the left of the clock display area. If there are a low number of “bars” present, you may experience no temperature display ( “--” ) or inaccuracy. Occasionally, due to intermittent physical obstructions (such as vehicle traffic, etc.) or other environmental interference, the signal may be lost. If the sensor batteries are low the signal will be lost as well. After a signal loss- the display console will automatically begin to search for the wireless multi-sensor and attempt to re-acquire the wireless signal. In the event that the signal is lost completely and cannot be re-acquired, the weather ticker will display “SENSOR SIGNAL LOST- CHECK BATTERIES AND PLACEMENT”. See “troubleshooting” for more information.

13