Acu-Rite 1035 Installing Batteries - 5-in-1 Multi-Sensor, Installing Batteries - Display Console

SETUP

Installing Batteries - 5-in-1 Multi-Sensor

A B C	!	SET “ABC” SWITCH TO MATCH
		DISPLAY CONSOLE
		“ABC” SWITCH SELECTION

1 Remove Battery
Compartment
Cover	3	Remove Tape
		& Rain Gauge
2 Install 4		Stabilizer
		-discard-
“AA” Alkaline*
Batteries

*install lithium batteries for

use in temperatures below -4ºF

NOTE: Make sure to remove the tape and small plastic rain gauge stabilizer installed in the bottom of the sensor housing. The rain gauge will not function until this is removed.

BATTERIES MUST BE INSTALLED FOR THE INTEGRATED SENSOR TO OPERATE: The integrated sensor features a solar cell for collecting sunlight and converting it into usable power, this feature is intended to EXTEND the life of the batteries you install. This sensor REQUIRES batteries be installed to operate, and will not function on solar power alone.

PLEASE DISPOSE OF OLD OR DEFECTIVE BATTERIES IN AN ENVIRONMENTALLY SAFE WAY AND IN ACCORDANCE WITH YOUR LOCAL LAWS AND REGULATIONS.

2

Installing Batteries - Display Console

A B C	!	SET “ABC” SWITCH TO MATCH
		SENSOR “ABC” SWITCH SELECTION

	Remove
WRITE DOWN YOUR	Battery
	Compartment
DEVICE I.D. / M.A.C.	Cover

You will need the device ID number that is printed on the back of the display for (OPTIONAL) online connectivity,

so keep it handy!

	Install 6
Connect	“AA”
power	Alkaline
adaptor	Batteries

The display console will operate under battery power OR AC power alone, however, it is recommended that batteries be installed to retain records and to ensure continued operation during a power outage.

Note that the Weather Ticker will display a scrolling welcome message and basic instructions after powering on.

IMPORTANT: set the time and date as soon as possible, weather history data is driven by the time and date and will record incorrect time and date information if the time and date are not set correctly.

3