
Setting System Configurations
Restoring Factory Default Settings
The following table summarizes the factory default settings. The procedure restores all settings to their factory defaults.
Setting | Factory Default |
System |
|
Logon Password | ENTER |
Enable | |
Craft Port Access) |
|
ADSL |
|
Startup Mode | Adaptive Rate |
Margin | 4 dB |
Upstream Data Rate | 928 kbps - maximum |
| 64 kbps - minimum |
Downstream Data Rate | 7040 kbps - maximum |
| 64 kbps - minimum |
SNR Margin Threshold | 3 dB |
ES Threshold | 100 |
Alarm Severity | E, enabled as a minor alarm |
Interleave | 4 ns |
|
|
Bridging |
|
Bridge Aging Time | 300 |
1From the System Configuration menu (page 16), type 4 to select Factory Default Configuration.
The following message displays: This will reset all the configurations and the ADSL modem. Are you sure? (Y/N)
2Do one of the following:
•
•
Type Y to reset the modem. When you type Y , the modem restarts with the factory default settings in effect. The following message displays: NVRAM Updated.
Type N to discontinue this procedure.
When you select yes to restore the factory default configuration, the modem automatically writes the factory default values to NVRAM and resets the ADSL link between the Megabit Modem 310F and 320F. You are automatically logged off the modem(s) and must log on again.
18 | Megabit Modem 310F and 320F User Manual |