ADC 500L LED, ADSL S, HECKING, NDICATIONS, SETTING UP ADSL SERVICE

CHECKING

LED INDICATIONS

PRELIMINARYChapter 3: Installing the Modem

SETTING UP ADSL SERVICE

The service provider sets up the ADSL parameters for your service. The modem must have the ADSL SYNC LED lit before you can connect sessions with your service provider. Verify SYNC in the following section, “Checking LED Indications.”

The following table describes LED indications for all operational modes. LEDs on the modem

	front panel (page 16) provide continual status at-a-glance for network and modem connections.
							RY
	LED	State		Description
	PWR	On green		Modem has power.		A
		Off		Modem does not have power.
				LAN
	LINK	On green		A PC, hub, or other network device is connected to the modem
				10/100BASE-T interface.
					N
		Off		I
				No device is connected to the modem 10/100BASE-T interface.
	TX	Flashing green		Modem is transmitting data to devices on the LAN.
		Off		Modem is not transmitting data to the LAN.
	RX	Flashing green		Modem is receiving data from devices on the LAN.
		Off		ModemMis not receiving data from the LAN.
			I
				ADSL
	SYNC	On green		ADSL transceiver is synchronized and in normal operation mode.
		Flashing green		ADSL transceiver is in a start-up sequence.
		Off		ADSL transceiver is not synchronized or is in a mode other than
				normal operation or start-up.
	TX	Flashing green		Modem is transmitting data to the service provider.
		EL
		Off		Modem is not transmitting data to the service provider.
	RX	Flashing green		Modem is receiving data from the service provider.
		Off		Modem is not receiving data from the service provider.
	MAR	On green		ADSL margin is at or above the value set by the service provider.
PR		Off		ADSL margin is below the value set by the service provider.
		On yellow		Telephone receiver is off hook.
	OH
		Off		Telephone receiver is on hook.

Megabit Modem 500L Installation Manual 15