Selecting a Configuration ModelPRELIMINARY
SELECTING A CONFIGURATION MODELThere are many configuration options for the Megabit Modem 500L from which you can select.
Select the following options are recommended for enhanced performance: | RY |
|
• DHCP not selected to allow the user to manually enter an IP address to the PC
• NAT to map the public IP addresses (proxy IP addresses) acquired from the service provider to the PC IP address
|
|
|
|
|
| A |
| DHCP | NAT |
| How WAN IP Address |
| |
|
|
|
| |||
|
| Acquired |
|
| ||
|
|
|
|
|
| |
|
|
|
|
|
|
|
| On | On |
| Fixed |
|
|
|
|
|
|
|
|
|
|
|
|
| I |
|
|
The following is a recommended procedure for configuring the Megabit Modem 500L: | ||||||
|
|
| M |
|
| |
1 Complete the WAN configuration (page 36). It is optional to map a LAN user to each PPP | ||||||
over ATM session at this time. You can perform thisNat a later time (see Step 4) after the | ||||||
modem dynamically serves IP addresses to LAN users or you have manually assigned IP | ||||||
addresses to LAN users. | I |
|
|
| ||
|
|
|
|
| ||
2 On the EasySession page: |
|
|
|
|
| |
EL |
|
|
|
| ||
a Select the session you want active then click Enable. The modem sets up the session | ||||||
with the service provider. The Up radio button next to the session(s) will indicate that | ||||||
the session was successfully set up. |
|
|
| |||
b When dynamically acquiring an IP address from the service provider, the session | ||||||
receives the IP address at this time. |
|
|
| |||
PR |
|
|
|
|
| |
3 Set up the LAN side configuration (page 39). |
|
| ||||
4 Map the IP address for the PC to a session (page 38).
34 | Megabit Modem 500L Installation Manual |