Configuring PPP over ATM Sessions

PRELIMINARY

 

 

• The modem automatically assigns the Start IP Address for the first device on the LAN as one address higher than the Ethernet port on the modem, when DHCP is enabled.

 

You cannot edit this field.

 

RY

 

 

 

Ž

Enter the IP address for a device that will be the Primary DNS. The primary Domain

 

Name System (DNS) device translates human-readable machine names into IP

 

addresses. (See page 59 for more information on DNS resolution.)

 

• Enter the IP address for a device that will be the Secondary DNS. The DNS device

 

translates human-readable machine names into IP addresses. (See page 59 for more

 

information on DNS resolution.)

A

 

 

•

The modem automatically enters the Gateway IP address which is the same

 

IP address as the LAN (Ethernet) 10/100BASE-T port of the modem. You cannot

 

edit this field.

 

 

‘ Click Static NAT Table to open a dialog in which you can map inbound Internet traffic

 

to specific sessions. Go to the section on “Defining Static NAT Entries” on page 41

to configure these parameters. Configuring Static NAT entries is optional.

 

 

I

 

 

M

4 Click Submit after completing the LAN configuration page.

5 After changing a LAN IP address and subnet mask (orNchanging the IP address and subnet

mask), effect the configuration by completing the procedures for “Saving the

Configuration” on page 21.

I

 

 

EL

 

PR

 

 

40

Megabit Modem 500L Installation Manual