Manuals / Brands / Computer Equipment / Switch / ADC / Computer Equipment / Switch

ADC Circuit Breaker Panel With Reset Switch 4.1 Installation Tools Required, 4.2 Materials Required, 4.3 Pre-Installation Testing

1 40

Download 40 pages, 3.1 Mb

ADCP-80-570 • Issue 2 • March 2006

Page 13

© 2006, ADC Telecommunications, Inc.

4.1 Installation Tools Required

The following tools are required to install the circuit breaker panel:

• Screwdrivers (both Phillips and flatblade)

• Torque screwdriver calibrated in pound-force inches or Newton meters

• 3/8-inch and 7/16-inch bits (for torque screwdriver)

• Wire cutter

• Wire stripper

• Compression lug crimper

• Multimeter

•Heat gun

4.2 Materials Required

The following materials are required to install th e circuit breaker panel:

• Insulated copper wire for input and output power wires (see Appendix A)

• Heat-shrink tubing

• Multimeter

4.3 Pre-Installation Testing

Each circuit breaker panel is thoroughly tested at the ADC factory before being shipped.

However, before the panel is installed, continuity tests should be performed to verify that no

internal damage has occurred during shipping and handling.

Using a multimeter that is set to perform a continuity check, perform the following tests.

Contents

Main Page Page Page ABOUT THIS MANUAL STANDARD CERTIFICATION ADMONISHMENTS GENERAL SAFETY PRECAUTIONS LIST OF ACRONYMS 1 PRODUCT DESCRIPTION 1.1 Product Functions and Features 1.2 Panel Components ADCP-80-570 Issue 2 March 2006 Figure 1. Circuit Breaker Panel Components Page 2 2006, ADC Telecommunications, Inc. FRONT VIEW REAR VIEW 1.3 Packaged Hardware ADCP-80-570 Issue 2 March 2006 Page 4 2006, ADC Telecommunications, Inc. 1.4 Power Buses Figure 3. Circuit Breaker Panel Block Diagram 1.5 Input Voltage 1.6 Input Connectors 1.7 Output Voltage 1.8 Output Connectors 1.9 Chassis Ground Connections 1.10 Circuit Breakers 1.11 Power-on Indicators 1.12 Breaker Alarm Indicators 1.13 Alarm Operation 1.14 Alarm Connections 1.15 Reset Switch 1.16 Circuit Breaker Designation Card and Holder 1.17 Voltage Designation Label 1.18 Material and Finish 1.19 Cooling 1.20 Protective Covers 1.21 Mounting 1.22 Specifications 1.23 Dimensions 2 ACCESSORIES 3 UNPACKING AND INSPECTION 4 INSTALLATION 4.1 Installation Tools Required 4.2 Materials Required 4.3 Pre-Installation Testing Page Page 4.4 Cable Management Bar (Optional Accessory) 4.5 Mounting Panel on Rack Page 4.6 Installing Designation Cards 4.7 Installing Voltage Designation Label 4.8 Installing Ground Wires 4.9 Connecting Alarms 4.10 Connecting Output 4.11 Connecting Input Page 4.12 Installing Protective Covers 5 TESTING 5.1 Testing Power Indicators and Connection Polarity 5.2 Testing Alarm Contacts Normal State 6 OPERATION 6.1 Connecting New Equipment 6.2 Using the Reset Switch 7 MAINTENANCE 7.1 Performing a Routine Inspection 7.2 Replacing a Circuit Breaker Page Page 8 CUSTOMER INFORMATION AND ASSISTANCE Page APPENDIX A: ALLOWABLE AMPACITIES OF INSULATED CONDUCTORS