To adjust the PLII Music Parameters:
1.Press the menu button to enter the main menu. The main menu appears on the OSD. The cursor on the OSD should be pointing to the input configuration menu and input config appears on the front panel display.
2.Press the 
button until the PLII music parameter menu is selected. The cursor on the OSD should be pointing to the PLII music parameter menu and PLII music parameter appears on the front panel display.
3.Press select to enter the PLII music parameter menu. The PLII music parameter menu appears on the front panel display and the OSD. The selected menu item should be panorama.
4.Use the 
and 
buttons to select between on and off. When this setting is on, Pro Logic II’s panorama circuits will blend an amount of the front channel information into the side speakers so that the sound field appears to wrap around the front and sides of the soundstage. Experiment with a variety of program sources to see if this effect is one you prefer.
5.Press the 
button to select the dimension menu.
6.Use the 
and 
buttons to cycle through the dimension options. The dimension settings appear as follows as you scroll through them:
step 0, step 1, step 2, step 3,
You can scroll in either direction using the 
and 
buttons.
The dimension control uses special circuitry to give the impression that the “center” of the sound field is moving towards the front or rear of the room. Experiment with a vari- ety of program sources to see if this effect is one you prefer. Use as much or as little dimension as you feel is needed.
7.Press the 
button to select the C width menu.
8.Use the 
and 
buttons to cycle through the C width options. The C width settings appear as follows as you
scroll through them:
step 0, step 1, step 2, step 3, step 4, step 5, step 6, step 7
You can scroll in either direction using the 
and 
buttons.
Depending on how the center width control is set, you may adjust the apparent placement of the center channel image so that it is heard only from the center speaker, so that it is blended into the left and right speakers as a phantom image, or that it is blended among the front left, center and right speakers in varying amounts. As with the other Pro Logic II controls, the use of this setting and the degree to which it is used is a matter of personal preference.
9.Center image can also be adjusted.
10.Press the menu button to return to the main menu, or press the menu button twice to exit.
3.9 Room Two Configuration
This menu controls the setting for your second room and the output from the room 2 out jacks on the rear of the
This function can be accessed in three ways. You can press the rm.2 button on the remote control, you can access this feature through the Main menu, or from the front panel (please refer to the front panel interface overview section in this manual for details). The room two menu is shown below.
To adjust the room two settings:
1.Press the menu button to enter the main menu. The main menu appears on the OSD. The cursor on the OSD should be pointing to the input configuration menu.
2.Press the 
button until the room two menu is selected. The cursor on the OSD should be pointing to the room two menu and room two appears.
3.Press select to enter the room two menu. The room two menu appears on the front panel display and the OSD. The selected menu item should be room two.
4.Use the 
and 
buttons to select whether you want
44 ADCOM
