2.5 Programming the GRC-810 Remote
As you’ve already seen, the
Using Pre Programmed Commands
Using the remote controller’s pre programmed commands is simple. For most
1.Press the main source selector button. This tells the remote that you want to use
2.Press the appropriate function button (volume up, volume down, etc.) If you’ve selected a button that actually triggers a
For tuner functions (changing stations, etc.):
1.Press the tuner source selector button. It will flash red.
2.Press the tuning up (or tuning down) function button
to change stations. The tuner source selector will flash red to confirm that the function button you’ve selected actually triggers a command. (Again, use the table to see which buttons are pre programmed.) Press the CD source selector first to access pre programmed commands for ADCOM CD players.
Note: You can program new commands over the pre pro- grammed commands in tuner and CD if you wish. However, you cannot program any buttons, even those unpro- grammed with
Programming Your Own Commands
You can supplement pre programmed commands with com- mands to operate other components. Before you begin to follow these steps, note the status LED located at the top left corner just above the remote’s button panel: It will flash red, orange, or green to signal particular functions as you enter new commands into your ADCOM remote.
Begin by deciding which source component’s commands you will be transferring to the ADCOM remote. Then press
the appropriate source selector button. For example, if you’re teaching your ADCOM remote commands for your video 1 source, press the vid 1 source selector first. You can “teach” your remote new commands for any function button (except backlight) after you’ve selected DVD, VCR, CD, vid 1, vid 2, vid 3 and tuner.
1.Place the source component’s remote “head to head” with the ADCOM remote. They should be in line with each other about 2 to 3 inches apart.
2.Press the ADCOM remote’s appropriate source selector and select buttons simultaneously. Hold both buttons until the status LED turns orange and the source selector but- ton glows red. Both indicators should remain lit.
3.Decide which function button on the ADCOM remote you want to learn a new command. Press it. The orange status LED will begin to flash and the source selector LED will go out.
4.Find the corresponding button on the source compo- nent’s remote. Press and hold it until the status LED on the ADCOM remote flashes green once and remains green until the button on the source remote is released. Once the button on the source remote is released, the status LED will start flashing orange again.
5.Verify that the ADCOM remote has learned the new command by pressing and holding the same button on the source remote. The ADCOM remote’s status LED should flash green twice and then go back to steady orange. This indicates successful programming. Release the button on the source remote.
Repeat steps 3 through 5 for any other commands you want to teach your ADCOM remote for that source component.
Save the commands you’ve just programmed into the ADCOM remote by pressing and holding the appropriate source selector and select buttons simultaneously. Hold until the status LED and source selector LED flash twice and then go out. Repeat these steps for any other source commands you wish to program.
Deleting Individual Commands
1.Press the ADCOM remote’s source selector and select buttons simultaneously and hold until the orange status LED and the source selector button glow steadily.
2.Press the function button you wish to clear. The status LED will flash continuously.
32 ADCOM
