3.Press select to enter the channel calibration menu. The channel calibration menu appears on the front panel display and the OSD. The selected menu item should be left front.
A special test tone will be generated allowing you to measure the output of the speaker that’s playing. Adjust the master volume as needed.
4.Use the 
and 
buttons to adjust the speaker level. You can adjust the selected channel level in 1dB steps across a range of
5.Press the 
button when you have finished making the left front level adjustment. Repeat steps 5 and 6 until you have completed setting the level for each speaker in your system.
6.When you have finished adjusting the level for all the speakers in your system, press the 
button to select the return to main menu option.
7.Press the select or menu button to return to the main menu, or press the menu button twice to exit. You can also perform this calibration at any time by using the built in test tone, by pressing the ch. cal button on the
To set channel levels using the test tone function:
1.Press the ch. cal button on the remote (make sure to press the main button first). This will produce a display that shows:
When you select this function, the
left front, center front, right front, right surr(ound), right back (surround), left back (surround), left surr(ound), subwoofer
2.Use the 
and 
buttons to adjust the speaker level. You can adjust the selected channel level in 1dB steps across a range of
While you are adjusting each speaker, the test tone will remain on that channel until you have stopped changing
the volume for a few seconds. The unit will then resume cycling the test tone from speaker to speaker, until you touch the ch. cal button again.
Note: Speakers that you selected “none” for in the speaker config menu will not appear.
3.Press the ch. cal button on the remote control again to exit the test tone function.
Channel Trim
Channel trim allows you to fine tune the channel levels to compensate for various soundtrack anomalies. For example, you may play a movie and find that the center (dialogue) channel is weak, making the movie hard to follow. Simply trimming the center channel up a dB
or two can fix the problem. Or another film may have substantially more bass than normal and trimming the subwoofer channel down a dB or two may help balance the sound correctly.
This function can be accessed in two ways. You can press the ch. trim button on the remote control, or you can access this feature through the main menu. The channel trim menu is shown below.
To adjust channel trim from the main menu:
1.While playing the program material with output that you wish to fine tune, press the menu button to enter the main menu.
The main menu appears on the front panel display and the OSD. The cursor on the OSD should be pointing to the input configuration menu and input config appears on the front panel display.
2.Press the 
button until the channel trim menu is selected. The cursor on the OSD should be pointing to the channel trim menu and channel trim appears on the front panel display.
3.Press select to enter the channel trim menu. The channel trim menu appears on the front panel display and
40 ADCOM
