Addonics Technologies RCHDSAES manual Ruby Enclosure, Switch, Ruby Drive Cradle

Step 4 Turn over the PCB and secure the hard drive to the PCB with the	Ruby Enclosure
mounting screws that come with the kit.

Step 5 Mount the board to the bottom cover.

Step 6 Put the top cover on by holding it in near vertical position and sliding the two metal clips inside the two small slots on the rear of the bottom cover.

Step 7 Lower the front of the top cover and making sure the two covers lined up properly. Tighten the small retaining screw on the front of the bottom cover to close the enclosure.

Switch Power LED and

Drive Access LED

Switch:

INT: This mode is used when the enclosure is placed inside a drive cradle. For mobile rack kits, this is the mode used.

EXT: This mode is used if the enclosure is used as an external hard drive.

Ruby Drive Cradle

Note: You can only use one power connector at a time. Either use the 4-pin Molex or 15-pin SATA connector but not simultaneously use them.

4-pin Molex power connector

15-pin SATA	7-pin SATA
power connector	data connector

Mounting holes for 3 ½” drive bay