ADIC 5.1 Installation Instructions, Manufacturer Model Firmware Revision Level Requirements

Therefore, if you use DC for your AIT-1 and/or AIT-2 drives and you are upgrading to VolServ 5.1, you will need to reconfigure the drive type designator to DM, otherwise VolServ will interpret DC as an AIT-3 drive.

VolServ 5.1 has been certified with DAS/AMU firmware revision 3.10e which supports AIT-1 and AIT-2 drives. Firmware revision 3.11 and above supports AIT-3, although ADIC has not yet certified this revision.

Manufacturer		Model	Firmware Revision Level Requirements
ADIC (AMU-attached)	•	Scalar 1000	• with LTO drives: 4.00.0006
			• with DLT or AIT drives: 3.00.0018 or
			.0017
	•	AML/2
	•	AML/E
	•	AML/J
ADIC (SCSI-attached; Solaris 8 and IRIX	•	Scalar 100	• Rev 2.60.0040
6.5.15-6.5.17 only)	•	Scalar 1000	• with LTO drives: 4.00.0006
			• with DLT or AIT drives: 3.00.0018 or
			.0017
	•	Scalar 10K	Rev 140A.00002
ADIC (SDLC-attached; Version 2.x)	•	Scalar 10K	Rev 140A.00002
STK (3480 mediatype only)	•	Silo ACS 4400
Network-attached using Automatic	•	Wolfcreek
Cartridge System Library Software		ACS 9360
(ACSLS) as a library interface.
STK L180 (SCSI-attached; Solaris 8 and	•	3.01.02
IRIX 6.5.15-6.5.17 only)	•	3.01.02
STK L700 (SCSI-attached; Solaris 8 and
IRIX 6.5.15-6.5.17 only)

Installation Instructions

To install VolServ 5.1, use the following instructions.

Step 1. Log on as a root user:

#su - root

Step 2. Install VolServ 5.1 as described in the Installing VolServ book (version 5.0).

NOTE: If you have an installation of VolServ that is earlier than 3.0 and you want to upgrade to VolServ 5.1, you must first upgrade to VolServ 3.0 to accommodate the change of the Ingres database to the Linter database.

Page 4 of 14 VolServ Version 5.1 — 6-00572-01