Advantech AIMB-250 Keyboard Error or no Keyboard Present, Memory Size has Changed Since Last Boot

AIMB-250 Series

3.5.13 Exit Without Save			85
4	Drivers Installation		86
		............................................................................................................	87
5	Mechanical Drawing		88
Appendix A: AWARD BIOS POST Messages			90
		............................................................................................................................	91
		..........................................................................................................................	91
		.................................................................................................................	91
1.	CMOS BATTERY HAS FAILED		91
2.		CMOS CHECKSUM ERROR	91
3.	DISK BOOT FAILURE, INSERT SYSTEM DISK AND PRESS ENTER		91
4.	DISKETTE DRIVES OR TYPES MISMATCH ERROR - RUN SETUP		91
5.	DISPLAY SWITCH IS SET INCORRECTLY		92
6.	DISPLAY TYPE HAS CHANGED SINCE LAST BOOT		92
7.	EISA Configuration Checksum Error PLEASE RUN EISA CONFIGURATION UTILITY		92
8.	EISA Configuration Is Not Complete PLEASE RUN EISA CONFIGURATION UTILITY		92
9.	ERROR ENCOUNTERED INITIALIZING HARD DRIVE		92
10.		ERROR INITIALIZING HARD DISK CONTROLLER	92
11.		FLOPPY DISK CNTRLR ERROR OR NO CNTRLR PRESENT	92
12.		Invalid EISA Configuration PLEASE RUN EISA CONFIGURATION UTILITY	93
13.		KEYBOARD ERROR OR NO KEYBOARD PRESENT	93
14.		Memory Address Error at	93
15.		Memory parity Error at	93
16.		MEMORY SIZE HAS CHANGED SINCE LAST BOOT	93
17.		Memory Verify Error at	93
18.		OFFENDING ADDRESS NOT FOUND	93
19.		OFFENDING SEGMENT:	93
20.		PRESS A KEY TO REBOOT	94
21.		PRESS F1 TO DISABLE NMI, F2 TO REBOOT	94
22.		RAM PARITY ERROR - CHECKING FOR SEGMENT	94
23.		Should Be Empty But EISA Board Found PLEASE RUN EISA CONFIGURATION UTILITY	94
24.		Should Have EISA Board But Not Found PLEASE RUN EISA CONFIGURATION UTILITY	94
25.		Slot Not Empty	94
26.		SYSTEM HALTED, (CTRL-ALT-DEL) TO REBOOT	94
27.		Wrong Board In Slot PLEASE RUN EISA CONFIGURATION UTILITY	95
28.		FLOPPY DISK(S) fail (80) → Unable to reset floppy subsystem	95
29.		FLOPPY DISK(S) fail (40) → Floppy Type dismatch	95
30.		Hard Disk(s) fail (80) → HDD reset failed	95
31.		Hard Disk(s) fail (40) → HDD controller diagnostics failed	95
32.		Hard Disk(s) fail (20) → HDD initialization error	95

8 AIMB-250 Series User’s Manual