AEG 1850 manual Installation on vibrating floors, Compensate for floor unevenness

Installation on vibrating floors

Where the floor vibrates, particularly in the case of wooden beam floors with pliable boards, securely screw a water-resistant wooden panel at least 15mm thick onto at least 2 floor planks. If possible, set up the unit in the corner of a room, as the wooden floor is optimally re- strained there and is therefore least likely to be subject to resonance vi- brations.

Compensate for floor unevenness

3	Automatic adjustment foot: The rear left foot of your washing ma-
	chine is designed as a spring leg. This means that it guarantees that

your unit will stand securely even at high spin speeds.

If, nevertheless, the washing machine is unstable during spinning, please proceed as follows:

01. Set the three adjusted feet at the

nominal value of 10 mm. To do

this, use the supplied special spanner to remove the transport safeguard.

If the automatically adjusting

foot does not reach the floor: 2. Automatic adjustment foot (rear

left) manually for extending the reqired dimension.

3. If necessary, check the setting with a spirit level.

Caution! Never use wood, card or similar underlays to level out minor floor unevenness. Instead, always adjust

the adjustment foot.

58