2.Defrost the freezer compartment prior to cleaning (see "Defrosting" section).
3.Switch the appliance off and remove the plug from the mains, or switch off or turn out the circuit breaker or fuse.
4.Clean the appliance and the interior accessories with a cloth and lukewarm water. Commercially available dish washing detergents may also be used.
5.After cleaning wipe with fresh water and rub dry.
Accumulation of dust at the condenser increases energy consumption. For this reason carefully clean the condenser at the back of the appliance once a year with a soft brush or a vacuum cleaner.
Do not pull, move or damage any pipes and/or cables inside the cabinet.
Switching off the appliance
If the appliance is not going to be used for an extended period:
1.Remove all
2.Switch off the appliance by turning the temperature regulator to position "0".
3.Remove the mains plug or switch off or turn out the circuit breaker or fuse.
4.Defrost freezer compartment and clean thoroughly (see section: “Cleaning and Care”).
5.Leave the door open to avoid the build up of odours.
Your appliance needs air
For safety reasons, minimum ventila- tionmust be as shown Fig.
Attention: keep ventilation ope- nings clear of obstruction;
Rear spacers
In the bag with the documentation, there are two spacers which must be fitted.
Slacken the screws and insert the spacer under the screw head, then
Rehingeing the door
100 mm |
|
A | B |
10 mm | 10 mm |
NP00 |
|
PR153 |
|
Energy Saving Tips
The side at which the door opens can be changed from the right side (fac- tory adjustment) to the left side, if the installation site requires.
Warning! When changing the side at which the door opens, the appliance may not be connected to the mains. Remove plug from the mains befo- rehand.
•Do not install the appliance near cookers, radiators or other sources of warmth. High ambient temperatures cause longer, more frequent opera- tion of the compressor.
•Ensure sufficient air circulation and exhaust at the appliance base and at the back wall of the appliance. Never cover air vent openings.
•Do not place warm foods into the appliance. Allow warm foods to cool first.
•Only leave door open as long as necessary.
•Do not set temperature any colder than necessary.
•Put frozen food in the fridge to defrost. The cold in the frozen food will then be used to cool the fridge.
•Keep the heat emitting condenser, the metall grille on the rear wall of your appliance, always clean.
Procced as follow:
1.Remove the
2.Remove the bottom hinge (E) by unscrewing the two fixing screws.
3.Slide the door off pin (G); unscrew pin (G) and refit it on the opposite side.
4.Remove the two plugs, to reveal the holes for the hinge pivots,
| F | |
F | E | |
F | ||
| ||
| D | |
PR185 | F | |
|
32 | 25 |
