Operating instructions
29
Washing is not spun
properly, water is still
visible in the drum.
Drain hose is kinked. Remove kink.
Maximum pumping height
(drain height 1m above the
floor on which the machine
is standing) exceeded.
Please contact customer ser-
vice who have a retrofit kit
for pumping to heights of
greater than 1m.
Circulation pump is blocked. Switch off the machine and
unplug from the mains, clean
the circulation pump.
In the case of siphon con-
nection: siphon is blocked. Clean siphon.
It is not possible to
open the door.
Program is not yet finished;
M (ON/OFF) indicator lamp is
illuminated.
Wait until the M (ON/OFF)
indicator lamp extinguishes.
Rinse water is cloudy. This is probably due to using
a detergent with a high sili-
cate content.
No negative impact on the
rinsing results, possibly use
liquid detergent.
Remnants of detergent
are building up in the
detergent drawer.
Tap is not fully open. Open tap fully.
The sieve in the threaded fit-
ting on the water inlet hose
at the tap is blocked. Clean sieve.
Sieve on threaded fitting for
the water inlet hose on the
machine is blocked. Clean sieve.
Program selector skips
k (PRE WASH). k(PRE WASH) combined
with s(WOOLLENS).
k (PRE WASH) cannot be
combined with s
(WOOLLENS).
Program selector
remains stationary at
position 7 (SOAKING).
Position 7 (SOAKING) is com-
bined with s(WOOLLENS).
Position 7 (SOAKING) cannot
be combined with
s(WOOLLENS).
Stain remover is not
washed in. Position 1 (STAIN) is com-
bined with s(WOOLLENS).
Position 1 (STAIN) cannot be
combined with s
(WOOLLENS).
Malfunction Possible Cause Remedy