Installation and Connection Instructions
Levelling on uneven floors
Using the four adjustable threaded feet, compensation can be made for unevenness in the floor and the height of the appliance adjusted. The height can be adjusted over the range +10...
To adjust the feet use the special spanner supplied for removing the transport braces.
01.Slide the special key firmly onto the hexagon head of the threaded foot all the way to the stop.
2.Adjust the threaded feet so that the appliance is level and sits stably. The appliance must not rock across the corners when operating under load.
3.If necessary, check positioning with a spirit level.
Important! Never compensate for small areas of unevenness in the floor through the use of wooden wedges, cardboard or the like. Level- ling should only ever be performed by adjusting the feet.
Power supply
Details on the mains voltage,
type of current and the neces- sary fuse protection are to be found on the rating plate. The rating plate is above and
behind the door.
For permanent electrical con- nection within the electrical
circuit, provisions must be made which allow for electrical disconnec- tion of the appliance from the mains with a contact opening of at least 3 mm at all poles. Suitable devices include circuit breakers, fuses (threaded fuses must be entirely removed from the socket), ground fault circuit interrupters and contactors. Permanent connection may only be carried out by an authorised electrician.
;This appliance conforms to the following EC directives
–
–"EMC Directive" 89/336/EWG dated 3 May 1989 and Directive amendment 93/68/EWG
39
