AEG 60810 manual Let hose fitting is blocked

Problem	Possible cause	Remedy
E10 appears.	Tap turned off.	Turn on the tap.
indicator (END)	The filter in the threaded in-	Turn off the tap. Unscrew the
flashes 1x, at the same
time an acoustic signal	let hose fitting is blocked.	hose, take out the filter and
		clean it.
sounds 1x.
(Problems with water	Water tap is furred with	Check the tap and have it re-
inflow)	lime scale or is faulty.	paired, if necessary.
	The transit packaging has	Removing the transit pack-
The washing machine	not been removed.	aging.
vibrates when operating	The screw feet not correctly	Adjust the feet as described
or is not stable.
		in the installation and con-
	adjusted.
		nection instructions.
Washing has not been	Only a few large items of	Always load the drum as full
		as possible. Mix large and
spun.	washing in the drum.
		small items.
	Screw connection on the in-	Screw the inlet hose on
	let hose is leaking.	tightly.
	Drain hose is leaking.	Replace drain hose.
Water is running out	Drain pump cover is not	Close the cover properly.
from under the washing	closed properly.
machine.	Washing was caught in the	Load washing carefully for
	door.	the next wash.
	Emergency drain hose is	Close off emergency drain
	leaking.	hose properly.
Washing water is foam-		Follow the manufacturer's
ing excessively. At the	Probably too much deter-
		instructions exactly when
end of the washing cy-	gent has been used.
		measuring out detergent.
cle, the spin stops.
	Kink in drain hose.	Straighten the hose.
E20 appears.	Maximum pumping height	Please contact the Customer
	of 1m exceeded.	Care Department.
indicator (END)		Switch off the appliance.
flashes 2x, at the same
time an acoustic signal	Drain pump is blocked.	Disconnect the power plug.
sounds 2x.		Clean the drain pump. Re-
(Problems with water		move foreign bodies from
outflow)		the pump housing.
	For sink spigot connections:	Clean the sink spigot.
	The sink spigot is blocked.

20