Troubleshooting

 

 

 

 

 

 

Malfunction

Possible cause

Remedy

 

 

 

 

 

 

 

 

 

 

 

 

 

The height-adjustable screw

Adjust the feet according to

 

 

 

the installation and connec-

 

 

 

feet are not correctly set.

 

 

 

tion instruction.

 

 

 

 

 

 

 

 

 

 

 

 

There is only very little wash-

This does not hinder the

 

 

 

ing in the machine (e.g. only

machine from functioning

 

 

Washing machine

a bath robe).

correctly.

 

 

vibrates during opera-

 

 

 

 

 

Check that the outlet hose is

 

 

tion or is unsteady.

Water could not be com-

 

 

correctly laid and if applica-

 

 

 

pletely pumped out before

 

 

 

ble eliminate the kink or

 

 

 

the spin because

 

 

 

clean the suds pump and if

 

 

 

there is a kink in the outlet

 

 

 

necessary remove any for-

 

 

 

hose or the suds pump is

 

 

 

eign bodies from the pump

 

 

 

blocked.

 

 

 

housing.

 

 

 

 

 

 

 

 

 

 

 

The suds in the main

Probably too much washing

Only use as much as the

 

 

wash cycle create too

washing powder manufac-

 

 

powder was used.

 

 

much foam.

turer recommends.

 

 

 

 

 

 

 

 

 

 

 

The clamp on the inlet hose

Tighten the inlet hose.

 

 

 

is not tight.

 

 

 

 

 

 

 

 

 

 

 

 

The inlet hose has a leak.

Check the inlet hose and if

 

 

Water is leaking out

necessary replace it.

 

 

 

 

 

 

 

 

 

from under the wash-

The lid of the suds pump is

Close the lid correctly.

 

 

ing machine.

 

 

not correctly closed.

 

 

 

 

 

 

 

 

 

 

 

 

Washing is caught in the

Abort the program, remove

 

 

 

the washing caught in the

 

 

 

door.

 

 

 

door, start a new program.

 

 

 

 

 

 

 

 

 

 

 

Fabric softener is not

Suction cap in the compart-

 

 

 

added, w compart-

Clean the detergent com-

 

 

ment for fabric softener is

 

 

ment for fabric sof-

partment, fit the suction cap

 

 

not correctly fitted or is

 

 

tener is filled with

on firmly.

 

 

blocked.

 

 

water.

 

 

 

 

 

 

 

 

 

 

 

 

Washing has not been

Rinse hold is selected.

Deselect Rinse hold.

 

 

 

 

 

 

 

Pump out the water and set

 

 

spun, there is water left

The soaking program has

 

 

in the drum.

the main wash cycle

 

 

been completed.

 

 

 

required.

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

31

Page 31
Image 31
AEG 62600 operating instructions Feet are not correctly set Tion instruction