Operating instructions
Washing Cycle Complete/Removing the Washing
Once the washing program has come to an end, L (END) illuminates on the program progress display.
If o (RINSE HOLD) was selected, the indicator beside the O/s (START/PAUSE) button flashes.
0 1. After a RINSE HOLD, the water must first be pumped out:
–Press either the O/s (START/PAUSE) button (the washing will be spun in accordance with the program which has just been completed; the spin speed can also be changed during spinning using the spin speed/o (RINSE HOLD) button),
or
–turn the program selector to C (PUMP OUT), and press the O/s (START/PAUSE) button (the water is pumped out without spinning), or
–turn the program selector to D (SPIN) or F (SHORT SPIN), and press the O/s (START/PAUSE) button (the washing will be spun or short
spun).
At the end of this program step, the END indicator will illuminate.
2.Open the door.
As soon as the K (DOOR) indicator is green, the door can be opened.
3.Turn the program selector to I (OFF).
4.Remove the washing.
5.Close the water tap.
6.Pull the detergent drawer out a little after washing so that it can dry out. Leave the door ajar so that air can circulate in the washing machine.
3 | If the Å (OVERDOSING) indicator illuminates, then too much deter- |
| gent was used in the washing program just completed, and as a result |
an additional rinse performed. Next time you use the machine, observe the detergent manufacturer’s dosing instructions for the load to be washed!
Important! If the washing machine is not to be used for a long period: close the tap and isolate the washing machine from the mains.
23
