Care and cleaning |
|
23 | |
|
|
The pyrolytic cleaning procedure cannot start:
–If you do not remove the core temperature sensor plug from the socket, the display shows „C2“
–If you do not close the oven door correctly, the display shows „C3“.
2.Remove the worst of the residual dirt manually.
3.Set the Pyrolytic cleaning function 
(refer to "Oven functions").
4.Touch 
to activate the Pyro cleaning function.
5.Touch 
or 
to set the duration of the cleaning procedure:
–P1 1:30 for a low degree of dirt
–P2 2:00 for a usual degree of dirt
–P3 2:30 for a high degree of dirt.
Touch 
to confirm.
You can use the End function to delay start of the cleaning process.
During the Pyro cleaning the door is locked. The symbol 
and the bars of the heat indica- tor come up, until the door unlocks again.
The door unlocks when temperature inside the oven is under safety condition and Pyro cleaning is finished.
During pyrolytic cleaning the lamp is off.
Cleaning reminder
To remind you that the pyrolytic cleaning is necessary the cleaning reminder symbol flashes in the display 
after every deactivating the appliance for the next 10 seconds.
The cleaning reminder goes off from the display:
•After end of the pyrolytic cleaning function
•When you deactivate it in the Settings menu (refer to "Settings menu")
Telescopic shelf runners
You can remove the telescopic runners to clean the side walls.
Removing the telescopic runners
1.Pull the front of the telescopic runners
away from the side wall.
