3.Close the oven door until the first posi- tion (angle approximately 45°).

What to do if… 21

Removing the oven door

1. Open the oven door as far as it goes.

2.Lift up clamping levers (A) on the two door hinges fully.

3.Close the oven door until the first posi- tion (angle approximately 45°).

4.Hold of the oven door with one hand on each side and pull it away from the oven at an upwards angle.

5.Now you can remove the inner glass pan- els and clean them.

A

A

To install the door follow the procedure in reverse.

The number of glass panels depends on the model.

CAUTION!

Put the oven door with the outer side down on a soft and level surface to prevent scratches

Removing and cleaning the door glass panels

1.Remove the oven door.

2.Hold the door t (B) on the top edge of the

door at the two sides and push inwards to release the clip seal.

3. Pull the door t to the front to remove it.

4.Hold the door glass panels on their top edge one by one and pull them up out of the guide

5. Clean the door glass panels.

To install panels follow the procedure in re- verse. Install the smaller panel first, then the larger.

WHAT TO DO IF…

WARNING!

Refer to "Safety information" chapter.

Page 21
Image 21
AEG EE1000000 user manual What To Do If…, Close the oven door until the first posi- tion angle approximately