30Installation
Positioning and levelling
Install the machine on a flat hard floor.
Make sure that air circulation around the machine
is not impeded by carpets, rugs etc. Before placing it on small tiles, apply a rubber coating.
Never try to correct any unevenness in the floor by putting pieces of wood, cardboard or similar
materials under the machine. If it is impossible to avoid positioning the machine next to a gas cooker or coalburning stove, an in-
sulating panel covered with aluminium foil on the
side facing the cooker or stove, must be inserted between the two appliances.
The machine must not be installed in rooms where the temperature can drop below 0°C. The water inlet hose and the drain hose must not be kinked.
Please ensure that when the appliance is installed, it is easily accessible for the engineer in the event of a breakdown.
Carefully level by screwing the adjustable feet in or out. Never place cardboard, wood or similar materials under the machine to compensate for any unevenness in the floor.
Water inlet
This appliance must be connected to a cold water supply.
1. Connect the hose to a tap with a 3/4” thread. Always use the hose supplied with the appliance.
Do not use the hose from your previ- ous machine to connect to the water supply.
2. The other end of the inlet hose which connects to the machine can be turned as showed in the picture.
Do not place the inlet hose down- wards. Angle the hose to the left or right depending on the position of your water tap.
3.Set the hose correctly by loosening the ring nut. After positioning the inlet hose,
