AEG S 75400 KG8, 200372733 manual If something does not work

If something does not work

During operation of the appliance some smaller but annoying trouble can often occur, which does not require calling a technician out. In the following chart information is given about them to avoid unnecessary charges on serv- ice.

We draw your attention that operation of appliance goes with certain sounds (compressor- and circulating sound). This does not necessarily mean a fault has occurred, this goes together with the operation of the appliance.

We draw it to your attention again that the appliance operates discontinu- ously, so the stopping of compressor does not mean being no-current. That is why you must not touch the electrical parts of the appliance before break- ing the circuit.

Problem	Possible cause	Solution
It is too warm in the	Thermostatic control can be set incor-	Set the thermostat knob to higher
refrigerator.	rectly.	position.
	If products are not cold enough or	Place the products according to the
	placed incorrectly.	chapter „Storing in the refrigerator”.
	The door does not close tightly or it is	Check if the door closes well and the
	not shut properly.	gasket is unhurt and clean.
It is too warm in the	Thermostatic control can be set incor-	Set the thermostat knob to higher
	rectly.	position.
freezer.
	The door does not close tightly or it is	Check if the door closes well and the
	not shut properly.	gasket is unhurt and clean.
	Products in big quantity to be frozen	Wait some hours and then check the
	were put in.	temperature again.
	Products to be frozen are placed too	Place the products in a way so that
	closely to each other.	cold air could circulate among them.
Water flows at the	It is normal. During automatic defrost-
	ing frost melts on the back plate.
back plate in the
refrigerator.	The outlet of the chamber can be	Clean the outlet.
Water flows into the	clogged up.
chamber.	Products placed in can prevent water	Replace the products so that they can
	from flowing into the collector.
		not touch the back plate directly.
Water flows onto the	The melting water outlet flows not	Put the melting water outlet to the
	into the evaporative tray above the
floor.		evaporative tray.
	compressor.
There are too much	Products are not wrapped properly.	Wrap the products better.
frost and ice.	Doors are not shut properly or do not	Check if the doors close well and the
	close tightly.	gaskets are unhurt and clean.
	The thermostatic control can be set	Set the thermostat knob to a position
	incorrectly.	that gives higher temperature.

25