AEG 311704300, U7101-4 manual Fitting Into the Space Between Cabinets

FITTING INTO THE SPACE BETWEEN CABINETS

IMPORTANT: Ensure that the oven is switched off at the wall before any further work is carried out.

￿Position the appliance in front of the cabinet. See Fig. 12.

￿Take out all oven furniture before installation to reduce the weight you need to lift. The oven door should be taped up to keep it closed.

￿To place the appliance into the space between cabinetry follow the procedure below:

￿N.B. Two people will be required to carry out the lifting procedure.

Warning: Do not attempt to lift this appliance by the handle(s).

￿Each person should squat either side of the appliance.

￿Tilt the appliance so that your hands can support the underside of the appliance.

￿Keeping your back straight, raise the appliance to the correct height by straightening at the knees.

￿Rest the rear underside of the appliance on the mounting brackets while your hands support the front.

￿The appliance can be pushed fully into the space. Take care to avoid fouling the mains lead.

￿Ensure the appliance is central and level.

￿When the appliance is fully housed, screw the stability screws (supplied with the appliance) into the underside of the worksurface in the positions indicated (see Fig. 13), taking care not to distort the trim. It is advisable to turn each screw alternatively to avoid damaging the trim.

￿Place the heat deflector flush with the edge of the worksurface, (see Fig.14) with the cork spacers up over (see Fig.15) and screw into position using the screws supplied with the appliance. Failure to do this may cause damage to the underside of the work surface.

￿Replace the plinth board.

￿Switch on the appliance and refer the user to the operating instructions.

47

Fig. 12

Fig.13

WORK TOP

Fig.14

Fig.15

HEATSHIELD

LEVEL WITH FRONT EDGE OF WORK TOP

TOP OVEN

DOOR