AGFA DV-5000Z Inserting the SD memory card, Operating the Camera, To insert the SD memory card

10

Inserting the SD memory card

If your photo/video storage will exceed the built-in memory capacity of 32MB, then prior to using this camera you will need to load an SD memory card into the camera.

To insert the SD memory card

1.Hold the camera with the lens facing towards you.

2.Open the battery / SD card compartment by pressing the cover upwards and sliding it towards you. The cover will snap open.

3.Position the SD card so that the edge with the gold-pin connectors faces right and gently push the SD card in until it locks into place.

4.Close the battery / SD card compartment by pressing the cover and sliding it away from you. The cover will snap shut.

To remove the SD memory card

Push the edge of the SD card until it springs out from the SD memory card slot. Then, carefully remove the SD card.

Without the SD memory card, video and photos taken will be saved to the built- in memory of your Digital movie camera. Look at the indicator on the upper-right of the LCD screen to see where videos and photos will be stored.

Note: Removing the SD memory card during camera operation will power down the camera.

Operating the Camera

Turning on the Power

Install the battery and the SD memory card before turning on the Digital movie camera. Flip open the LCD panel in a

leftwards motion then take hold of the bottom-left corner of the LCD panel and swivel it upwards. The Power button can be seen on the inner top right side of your Digital movie camera. Press and hold the Power button for 3 seconds to turn on the Digital movie camera. The LCD screen will display a recording screen by default.

When the camera is on you can check the battery power level or external power indicator located in the bottom-left corner of the LCD panel.

Power indicator

AgfaPhoto DV-5000Z