ESG Family Signal Generators Post-Repair Procedures
Adjustments
Service Guide 6-7

Adjustments

The tables in this section list the adjustments that must be performed when a speciļ¬c
assembly is repaired or replaced. (Refer to the list below for the table that applies to your
signal generator.) Except where noted, all adjustments are automated using software. For
more information on adjustments, refer to the calibration guide.
For the ESG-A Series refer to Table 6-5 on page 6-8.
For the ESG-D Series refer to Table 6-6 on page 6-9.
For the ESG-AP Series refer to Table 6-7 on page 6-10.
For the ESG-DP Series refer to Table 6-8 on page 6-11.