ENGLISH

2.Assemble the two hitch braces to the inside of the hopper frame, one on each side, using two 1/4" x 1-1/2" hex bolts (A) and two 1/4" nylock nuts (D).DO NOTTIGHTEN YET. See figure 2.

3.Remove the nut from the middle bolt in the crossover tube and shaft support plate. Leave the bolt in place. See figure 2.

4.Assemble the hitch tube onto the middle bolt and secure it with the same nut you removed. DO NOT TIGHTEN YET. See figure 2.

IMPORTANT: The hitch tube must attach to the side of the crossover tube opposite the shaft support plate.

5.Assemble the two hitch braces to the hitch tube using a 1/4" x 1-1/2" hex bolt (A) and a 1/4" nylock nut(D). DO NOT TIGHTEN YET. See figure 2.

6.Tighten the nuts and bolts fastening the hitch braces to the hopper frame and the hitch tube, then tighten the middle lock nut fastening the hitch tube to the crossover tube. DO NOT COLLAPSE TUBES WHEN

TIGHTENING.

7.Select the end of the axle with no cross hole. Assemble a spacer (L), a 5/8" flat washer (G), a wheel (air valve facing out) and then another 5/8" flat washer (G) onto the axle. See figure 3.

8.Install a hub cap (Q) by tapping it carefully onto the axle with a hammer. See figure 3.

(L) SPACER

(G) 5/8" DIA.

FLAT WASHER

(Q) HUB CAP

(G) 5/8" DIA.

FLAT WASHER AIR VALVE

FIGURE 3

MIDDLE BOLT

HITCH

TUBE

(A)1/4" x 1-1/2"

HEX BOLTS

SHAFT

SUPPORT

PLATE CROSSOVER

TUBE

MIDDLE NUT

(D)1/4"

NYLOCK NUTS

9.Select the end of the axle containing the cross hole. Assemble a spacer (L), a 5/8" flat washer (G), a wheel (air valve facing out) and then another 5/8" flat washer

(G)onto the axle. Insert the 5/32" x 2" cotter pin (I) through the wheel hub and the axle and then spread the ends of the pin. See figure 4.

10.Install a hub cap (Q) by tapping it carefully onto the axle with a hammer. See figure 4.

(I) 5/32" x 2"

(L) SPACER

COTTER PIN

 

AIR VALVE

HITCH BRACE

HITCH BRACE

FIGURE 2

(G) 5/8" DIA.

(Q) HUB CAP FLAT WASHER

FIGURE 4

5