Agri-Fab 45-02115 6

ENGLISH

11.Turn the spreader upright on its wheels.

12.Assemble the hitch bracket to the top of the hitch tube using two 1/4" x 1" hex bolts (B) and 1/4" nylock nuts

(D). See figure 5.

13.Assemble the hitch pin (K) through the hitch bracket and the hitch tube and secure with the hair cotter pin

(J). See figure 5.

(K) HITCH PIN

(B) 1/4" x 1"

HEX BOLT

(D) 1/4" NYLOCK NUT

(J) HAIR COTTER PIN

FIGURE 5

14.Assemble the flow control link (O) (end with small hole) to the flow control arm using a 1/4" x 1" hex bolt (B), a nylon washer (E) and a 1/4" nylock nut (D). Tighten carefully. The flow control link should not be loose but should pivot with no more than slight resistance. See figure 6.

(O) FLOW CONTROL

15.Assemble the flow control arm to the flow control mounting bracket using a 1/4" x 1" hex bolt (B), two nylon washers (E) and a 1/4" nylock nut (D) as shown in figure 7. Tighten carefully. The flow control arm should pivot with a slight resistance.

16.Assemble the vinyl grip (P). See figure 7.

(P)VINYL GRIP

FLOW	FLOW CONTROL
FLOW	MOUNTING
CONTROL	BRACKET
ARM

(B) 1/4" x 1"

HEX BOLT

(D) 1/4"

NYLOCK NUT

(E)2 NYLON WASHERS

FIGURE 7

17.Place a 5/16" flat washer (F) onto the end of the flow control rod. Insert the end of the rod through the slot in the flow control mounting bracket and through the hole

in the flow control link (O). Secure with a 3/32" x 3/4" cotter pin (H). See figure 8.

LINK

FLOW

(H) 3/32"

CONTROL

ARM

(B) 1/4" x 1"

HEX BOLT

(D) 1/4"

NYLOCK NUT

SMALLEST

HOLE