ENGLISH
9.Assemble the front panel over the end of the cart using six 1/4" x 3/4" hex bolts and 1/4" nylock nuts as shown in figure 5. Leave two holes in the bottom of the panel empty as shown. With the cart body halves pulled together, tighten the bolts in the bottom of the front panel, then tighten the bolts in the sides. See figure
5.
At this time tighten the bolts assembled in step 4, which fasten the bottom of the cart together.
LEAVE HOLES OPEN FOR | 1/4" x 3/4" |
LATCH STAND BRACKET | HEX BOLTS |
1/4" NYLOCK NUT
1/4" NYLOCK NUT
FIGURE 5
11.Turn the latch stand bracket so that the aligning tab is at the rear (bottom) of the bracket. Assemble the latch stand bracket to the cart using four 1/4" x 3/4" hex bolts and 1/4" nylock nuts. TIGHTEN. See figure 7.
LATCH STAND BRACKET
1/4" x 3/4"
HEX BOLT
ALIGNING TAB
AT BOTTOM
1/4" NYLOCK NUT
FIGURE 7
10.Assemble the wheel support to the cart using eight 5/16" x 3/4" truss head bolts and 5/16" nylock nuts as shown in figure 6. Heads of bolts go on the inside of the cart.
Tighten.
5/16" x 3/4"
TRUSS HEAD BOLT
WHEEL
SUPPORT
5/16" NYLOCK
NUT
FIGURE 6
12.Assemble the two corner caps to the front corners of the cart using four 1/4" x 3/4" hex bolts and 1/4" nylock nuts. Also assemble two 1/4" x 3/4" hex bolts and 1/4" nylock nuts to the two rear corners of the cart.TIGHTEN. See figure 8.
CORNER CAP | 1/4" NYLOCK NUT |
1/4" x 3/4" | 1/4" NYLOCK | |
HEX BOLT | ||
NUT | ||
| ||
FIGURE 8 |
|
5