ENGLISH
IMPORTANT: Make sure drawbar tongue is securely locked to the latch stand bracket by the latch lock lever.
19.Turn cart over so that it rests right side up on its wheels.
20.Assemble the end of the hitch bracket (two holes) down through the slot at the front of the drawbar tongue. Fasten it to the tongue using the 3/8" x 1" hex bolt, and 3/8" nylock nut. Tighten. See figure 13.
21.Assemble the hitch pin through the hitch bracket and the tongue and secure with the 1/8" hair cotter pin. See figure 13.
HITCH PIN
3/8" x 1"
HEX BOLT
HITCH | TONGUE |
| |
BRACKET |
|
1/8" HAIR
COTTER
PIN
3/8" NYLOCK NUT
FIGURE 13
22.Place the tailgate down into the tailgate guides so that the holes in the bottom lip of tailgate fit over the slotted head screws in the bottom of the cart. This completes the assembly of your cart.
OPERATION
CAUTION: VEHICLE BRAKING AND
STABILITY MAY BE AFFECTEDWITHTHE
ADDITION OF AN ACCESSORY OR AN
ATTACHMENT.BE AWARE OF CHANGING
CONDITIONS ON SLOPES.
1.Refer to the vehicle owners manual for instructions on safe operation on slopes.
2.Use the slope guide provided on page 8 of this manual to determine if slope angle is not too steep for safe operation.
3.For best handling and traction, distribute the weight of the load evenly in the cart.
4.Always test to make sure your tractor has adequate towing and braking capabilities whenever hauling a substantial amount of weight in your cart. Use extra caution when operating on slopes.
NOTE
DO NOT EXCEED 1200 LB. CAPACITY OF CART One cubic foot of dirt weighs approximately 80 lbs.
5.To dump material from the cart, remove the tailgate by lifting it straight up and out from between the guides. Release the spring latch on the tongue by pulling the latch lock lever forward, away from the cart. The cart bed will then tilt backwards to empty its contents. After emptying, pull the front of the bed down toward the cart tongue until the latch snaps into place. Replace the tailgate if desired.
6.The maximum towing speed for this cart is 10 m.p.h.
CAUTION: TO AVOID POSSIBLE
INJURY, BEFORE RELEASING THE
LATCH BE SURE THAT NO ONE IS
NEAR THE CART.
MAINTENANCE
1.At the beginning of each season, lubricate, with a light machine oil, the latch, the latch pivot bolt, and the area of the axle where the draw bar tongue pivots.
2.Grease or oil the wheel bearings periodically. Use automotive wheel bearing type grease or 20 weight oil.
3.Keep tires filled to the recommended tire pressure of
7