ENGLISH

7.Assemble a single spool assembly, a 1" long spacer, a double spool assembly, a 1.33" long spacer and a 3/4"

flat washer onto the short end of the shaft. See figure 4.

1.33" LONG

3/4" FLAT SPACER (T) WASHER (O)

1" LONG SPACER (S)

SHORT END

DOUBLE SPOOL

ASSEMBLY

SINGLE SPOOL

ASSEMBLY

FIGURE 4

8.Assemble a 2.38" long spacer, a 3/4" flat washer, the middle brace, a 3/4" flat washer, a 3.70" long spacer, a single spool assembly, a 1.33" long spacer, a double spool assembly, a 1.33" long spacer and a 3/4" flat washer onto the long end of the shaft. The bent lip of the middle brace must face the short end of the shaft.

See figure 5.

2.38" LONG

MIDDLE

SPACER (Q)

BRACE

3.70" LONG

SPACER (R)

1.33" LONG

SPACER (T)

3/4" FLAT WASHER (O)

SINGLE SPOOL

ASSEMBLY

DOUBLE SPOOL

ASSEMBLY 1.33" LONG

SPACER (T)

3/4" FLAT

WASHER (O)

FIGURE 5

9.Assemble an end plate to the end of the tray using four 5/16" x 3/4" hex bolts and four 5/16" nylock nuts.Repeat for other end. Do not tighten till step 20. See figure

6.

5/16" x 3/4"

HEX BOLT (E) 5/16" NYLOCK

NUT (K)

FIGURE 6

10.Assemble the tongue to the tray, placing the slot's lock- ing notch to the front. Use two 3/8" x 1" hex bolts, two 3/8" x 1-1/4" hex bolts, four 1/4" long spacers, and four

3/8" nylock nuts as shown in figure 7. Tighten.

3/8" x 1-1/4"

3/8" x 1" HEX BOLT (C) HEX BOLT (D)

1/4" LONG SPACERS (P)

LOCKING

NOTCH

3/8" NYLOCK NUT (J)

FIGURE 7