Agri-Fab 45-03261 (Figure 17), (Figure 17), (Figure 18), (Figure 19), IMPORTANT: Do not

ENGLISH

10.(Figure 17) Insert the hopper pivot rod through the upper hopper side tubes, the bag arm tubes and the stitched sleeve at the front of the wind screen.

11.Using a hammer, assemble each palnut (R) onto one end of the hopper pivot rod while bracing the other end against a solid object.

12.(Figure 17) Assemble a vinyl cap (V) onto the end of each bag arm tube.

	17
VINYL CAP (V)	PALNUT (R)
	HOPPER
	PIVOT ROD
	BAG ARM TUBE

IMPORTANT: Do not over bend the support rods during the following step. Over bending will cause the steel rods to loose supporting tension.

13.(Figure 18) Tip the hopper onto it's back to assemble the two hopper support rods. Place the ends of each rod into the upper and lower rear hopper tubes, bending the rod just enough to fit into the holes in the tubes.

14.(Figure 19) Secure the rope to the top center of the hopper bag frame.

15.(Figure 20)To assemble the hopper bag to the sweeper, slide the ends of the bag arm tubes into the ends of the sweeper's hitch tubes and secure with two 1/4" x 1-3/4" clevis pins (Q) and 3/32" hair cotter pins (N).

BAG ARM TUBE
3/32" HAIR	1/4" x 1-3/4"
COTTER PIN (N)	CLEVIS PIN (Q)

SUPPORT RODS