ENGLISH

3.(Figure 3) Attach the brush assembly with the black brush retainer to the left end of the brush shaft using two 1/4" x 1" hex bolts (G) and 1/4" nylock nuts (I). The brush retainer marked with black ink must be placed to the middle of the sweeper.

4.(Figure 3) Turn a wheel to rotate the brushes. (The wheels drive the brushes in one direction only.) The overlap bristles should be on the back side of the brush as it rotates.

3

1/4" x 1"

HEX BOLT (G)

BRUSH RETAINER

MARKED BLACK

5.Cut off the plastic tie that holds the height adjustment tube in place.

6.(Figure 4) Assemble the R.H. hitch tube to the sweeper housing using two 5/16" x 1-3/4" carriage bolts (C), and two 5/16" nylock nuts (J). Do not tighten yet. Repeat for the L.H. hitch tube.

5/16" NYLOCK NUT (J)

4

5/16" x 1-3/4"

CARRIAGE BOLT (C)

1/4" NYLOCK NUT (I)

7.(Figure 5) Fasten the hitch tubes together using two 5/16" x 3" hex bolts (A) and 5/16" nylock nuts (J). Do not tighten yet.

5

5/16"

NYLOCK NUT (J)

5/16" x 3" HEX BOLT (A)

6