ENGLISH
ASSEMBLY INSTRUCTIONS
TOOLS REQUIRED FOR ASSEMBLY
(1)Screwdriver
(1)Hammer
(2)7/16" Wrenches
(2)1/2" Wrenches
(2)9/16" Wrenches
NOTE: All 1/4" fl at washers should be assembled so that they rest directly against the poly tray surface.
1.Remove the hardware pack and all loose parts from the carton. Be sure the carton is empty before discarding.
2.Lay out all the parts shown on pages 2 and 3.
3.Assemblethelatchlockbetweenthelatchmountbrackets using a 1/4" x 1" hex bolt (E) and a 1/4" nylock nut (K). Tighten so that the latch lock can still pivot. Attach the extension spring (O) to the latch lock and the latch mount bracket as shown in fi gure 1.
4.Insert the 3/8" x 1" clevis pin (H) through the holes in the latch mount brackets and secure with a 1/8" hairpin cotter (N). See fi gure 1.
5.Assemble the latch lock subassembly to the rear tongue using two 1/4" x 1" hex bolts (E) and 1/4" nylock nuts
(K). Tighten. See fi gure 2.
6.Assemble the plastic cap (P) to the front end of the rear tongue as shown in fi gure 2.
LATCH LOCK
(E) 1/4" x 1" 
REAR
TONGUE
(K) 1/4" NYLOCK |
|
NUT | (P) PLASTIC CAP |
|
FIGURE 2
LATCH MOUNT | (K) 1/4" NYLOCK | |
BRACKETS | ||
NUT | ||
| ||
(E) 1/4" x 1" |
| |
HEX BOLT | (O) EXTENSION | |
| ||
| SPRING |
(N) 1/8" HAIRPIN COTTER
(H) 3/8" x 1" | LATCH LOCK | |
CLEVIS PIN | ||
|
FIGURE 1
7.Lay the rear tongue (open side facing up) onto theWheel Support. Assemble the axle through the wheel support and the tongue. See fi gure 3.
AXLE
REAR
TONGUE
WHEEL
SUPPORT
FIGURE 3
5