ENGLISH
8.Assemble the hitch bracket to the front tongue using two 3/8" x 1" hex bolts (B) and 3/8" nylock nuts (M). Tighten. See fi gure 4.
9.Assemble the leg stand bracket to the front tongue using two 5/16" x 1" hex bolts (C) and 5/16" nylock nuts (L). Tighten. See fi gure 4.
| LEG STAND | (B) 3/8" x 1" |
| BRACKET | |
| HEX BOLT | |
(C) 5/16" x 1" |
| |
|
| |
HEX BOLT |
| HITCH |
|
| |
|
| BRACKET |
12.Assemble a wheel with the valve stem facing out onto the axle.Assemble a hub cap (Q) by pressing or tapping it onto the axle. Repeat on other end of axle. See fi gure 6.
WHEEL AXLE
(Q) HUB CAP
FIGURE 6
FRONT
(L) 5/16" NYLOCK TONGUE NUT
FIGURE 4
(M) 3/8" NYLOCK NUT
13. Turn the assembled tongue, wheel support and wheels |
over to the upright position.Place the latch stand bracket |
onto the tongue between the latch lock assembly and |
the raised tab.Place the poly tray onto the wheel support |
and latch stand bracket. Fasten the tray to the wheel |
support using eight 5/16" x 3/4" truss head bolts (F) and |
5/16" nylock nuts (L). Do not tighten yet. See fi gure |
7. |
10.Place the front tongue inside the rear tongue as shown in fi gure 5. Fasten the tongues together using a 3/8" x 4" hex bolt (A) and a 3/8" nylock nut (M). Tighten, leaving the nut just loose enough that the tongues can pivot freely. See fi gure 5.
11.Insert the 3/8" x 4" clevis pin (G) through the tongues and secure with a 1/8" hairpin cotter (N), as shown in fi gure 5.
FRONT | (N) 1/8" HAIRPIN |
TONGUE | COTTER |
(M) 3/8"
NYLOCK NUT
(G) 3/8" x 4"
CLEVIS PIN (A) 3/8" x 4"
HEX BOLT
FIGURE 5
14. Place the latch stand plate between the latch stand |
bracket and the poly tray. See fi gure 7. |
(F) 5/16" x 3/4" |
TRUSS HEAD |
BOLT |
(L) 5/16"
NYLOCK NUT
LATCH
STAND
PLATE
LATCH STAND
BRACKET
FIGURE 7
6