ASSEMBLY INSTRUCTIONS

TOOLS REQUIRED FOR ASSEMBLY

(1)Hammer

(2)7/16" Wrenches

(1)Knife or Scissors

Lay out and identify parts and hardware using the illustrations on pages 2 and 3.

STEP 1: (SEE FIGURE 1)

•Remove pre-assembled 1/4" nylock nuts and spacers from inside of hopper tubes. Discard spacers once removed. Set aside 1/4" nylock nuts for use in step 2.

SPACER

PRE-ASSEMBLED 1/4" NYLOCK NUT

FIGURE 1

STEP 2: (SEE FIGURE 2)

•Attach the stand tube (C) to the hopper tubes using two 1/4-20 x 1-1/2 hex bolts (BB), the two pre- assembled bolts, and four 1/4-20 nylock nuts (FF).

BB

FF

FF

C

STEP 3: (SEE FIGURE 3)

THIS STEP FOR MODEL 45-0471 ONLY

•Apply liquid soap to the inside of the foam grip (II). Work the soap down the length of the grip to coat the inside. Slide the grip onto the handle (D) until it is centered.

HINT: The less soap left in the grip, the sooner the grip will dry and become snug on the handle.

II

D

FIGURE 3

FIGURE 2

4