STEP 7: (SEE FIGURE 7)

THIS STEP FOR MODEL 45-0471 ONLY

•Assemble the deflector rod (I), washer (GG), and connecting rod (H) to the deflector (F) using the thread forming screw (EE). Tighten the screw until it is just snug and then back it off 1/4 turn or until the deflector rod (H) will slide freely.

STEP 9: (SEE FIGURE 9)

THIS STEP FOR MODEL 45-0471 ONLY

•Attach the push rod clamp (JJ) and the eye clamp (KK) to the right side of the handle tube. You may need to gently tap the clamps into the holes in the tube with a hammer.

JJ

GG

EE

FIGURE 7

I

F

H

KK

STEP 8: (SEE FIGURE 8)

THIS STEP FOR MODEL 45-0471 ONLY

•Remove the bolt, washers and nuts that are assembled in the upper hole in the right hopper tube.

•Attach the deflector rod (I) to the upper hole in the hopper tube using the original bolt, washers and nut that were removed. Attach the deflector rod to the empty middle hole in the hopper tube using a 1/4" self threading screw (EE).

I

ORIGINAL

FASTENERS

EE

FIGURE 8

FIGURE 9

STEP 10: (SEE FIGURE 10)

THIS STEP FOR MODEL 45-0471 ONLY

•Slide the push rod (G) up through the eye clamp (KK) and then clip it into the push rod clamp (JJ).

•Attach the push rod to the connecting rod using a 1/4- 20 x 3/4" hex bolt (DD) and a 1/4-20 nylock nut (FF).

•Install the grip (LL) onto the end of the push rod.

G

LL

JJ

FF

KK

DD

G

FIGURE 10

6