Aigo PB2200 user manual Cleaning for Front Ventilation, Replacing Front Cover

Push the spring buttons on both sides and raise the rear part of Top Cover

It may be required to push the power switch down to completely remove the front cover.

Power Switch

Cleaning for Front Ventilation

Use vacuum cleaner to remove any dust or threads accumulation away from both the ventilation holes on front cover and ventilation grids on chassis exposed after removal of the front cover.

Front Ventilation Grids on Chassis

Ventilation Holes on Front Cover

Replacing Front Cover

Follow the opposite procedure as removing the front cover to replace the front cover in position. Please make sure the all hooks on front cover is well positioned into chassis. Please remember to check that the power switch is at “Off” position before power and signal connection.

Accessing Side Ventilation Grids

The operation to further clean the side ventilation grids requires much more highly technical maneuver. Therefore careful attentions must be taken throughout the further cleaning operations below. When the main unit is opened, there must be no liquid spill,

no electro-conductive material, no electric charged device come into the area of the main unit. Please also note that not to touch any component or cable inside.

Please first disconnect every

cable from the main unit and prepare enough space in front of the PB

system and lay a piece of clean soft clothe of appropriate size there to

prevent damage. With the back cable cover opened, push in the circled spring button in the above picture on both sides of chassis and raise the rear edge of the top cover. Apply some mild maneuver if there is already a pole display mounted.

Part 16